tag:blogger.com,1999:blog-6199076328004085103.post5694494813015924436..comments2023-06-18T02:27:09.387-07:00Comments on i-sobot hacking: Right-arm controlibothttp://www.blogger.com/profile/04690724959487125871noreply@blogger.comBlogger5125tag:blogger.com,1999:blog-6199076328004085103.post-38812232055784782132009-04-14T10:55:00.000-07:002009-04-14T10:55:00.000-07:00good job as soon as i get my i-sobot i will dissas...good job as soon as i get my i-sobot i will dissassemble it and try to control the servos with my pc serial port.Anonymousnoreply@blogger.comtag:blogger.com,1999:blog-6199076328004085103.post-18865975711202818732009-01-22T09:25:00.000-08:002009-01-22T09:25:00.000-08:00hi what about Embedded Comp Cubloc CB220 Starter K...hi what about Embedded Comp Cubloc CB220 Starter Kit, is it possible to controll i-sobot with this board ? Is it enven real to do something with i-sobot ? It is long time from last post ..Anonymoushttps://www.blogger.com/profile/12931869776537513803noreply@blogger.comtag:blogger.com,1999:blog-6199076328004085103.post-8529599366665777492007-12-14T00:18:00.000-08:002007-12-14T00:18:00.000-08:00ok so now i need to learn about UART :) ... thanks...ok so now i need to learn about UART :) ... thanks for these informationscedtathttps://www.blogger.com/profile/07587263236626298763noreply@blogger.comtag:blogger.com,1999:blog-6199076328004085103.post-49852895153888260482007-12-13T01:08:00.000-08:002007-12-13T01:08:00.000-08:00SCC32 is a servo controller that send s period pul...SCC32 is a servo controller that send s period pulses on each output. On I-SOBOT, the servo have a serial interface so you need a controller with UART. I am afraid that 4 UARTs are necessary, I will do motre tests soon or you can emulate UART with software. Then any microcontroller would do the job.ibothttps://www.blogger.com/profile/04690724959487125871noreply@blogger.comtag:blogger.com,1999:blog-6199076328004085103.post-38818181863802269602007-12-12T14:49:00.000-08:002007-12-12T14:49:00.000-08:00Hello, this blog is very interesting, i don't have...Hello, this blog is very interesting, i don't have the level to fully understand everything but i can't wait to ask you something ? Do you think it is actually possible to remove the main board to add a new board (less complicated) already supported on robotics frameworks like MSRS (microsoft robotics studio) ... i was thinking of a SCC32 lynxmotion controller ... it could be a nice and cheap body to play with instead of an expensive 1000$ robots !<BR/><BR/>Regards,<BR/>Cédric :)cedtathttps://www.blogger.com/profile/07587263236626298763noreply@blogger.com